MIL-DTL-46610F
4.5.6 Priming composition analysis. The analysis shall be made using standard
laboratory practices and procedures.
4.5.8 M82 percussion primer sensitivity test.
4.5.8.1 Non-functioning. One hundred and fifty (150) No. 34 primers for use in M82
percussion primers (Part No. 10522621-18) shall be loaded into M892 primers without container
charge assembly (less the black powder charge) and tested in accordance with paragraph 4.3.2
Nonfunctioning of MIL-P-46296C. Any primer assembled that fires shall be cause for rejection
of the lot.
4.5.8.2 Functioning. Three hundred (300) No. 34 primers for use in M82 percussion
primers (Part No. 10522621-18) shall be loaded into M82 primers without container charge
assembly (less the black powder charge) and tested in accordance with 4.3.3.1 of MIL-P-
46296C. If five or more primers fail to comply with the specified requirements, the lot shall be
rejected. If two but less than five defectives are found, a second sample of six hundred (600)
primers shall be tested. If the combined number of defective in both the first and second sample
is 5 or more, the lot shall be rejected.
5. PACKAGING
5.1 Packaging. For acquisition purposes, the packaging requirements shall be as
specified in the contract or order (see 6.2). When packaging of material is to be performed by
DoD or in-house contractor personnel, these personnel need to contact the responsible packaging
activity to ascertain packaging requirements. Packaging requirements are maintained by the
Inventory Control Point's packaging activities within the Military Service or Defense Agency, or
within the military service's system commands. Packaging data retrieval is available from the
managing Military Department of Defense Agency's automated packaging files, CD-ROM
products, or by contacting the responsible packaging activity.
6. NOTES
(This section contains information of a general or explanatory nature that may be helpful, but is
not mandatory.)
6.1 Intended use. Assemblies and components covered by this document are intended for
use with small arms ammunition and small arms weapons.
6.2 Acquisition requirements. Acquisition documents should specify the following:
a. Title, number and date of this specification.
b. Requirements for submission of first article sample.
c. Conformance verification.
d. Packaging requirements (see 5.1). Reference Drawing No. 1053577, entitled "Packing
and Marking Primers, Small Caliber Ammunition, Cartons, (Plastic Tray), Box,
Ammunition, M2A1"; Drawing No. 7553274, entitled "Packing and Marking, Primers,
22
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business