MIL-C-46934B (MU)
3.10 Grain configuration. - The grain configuration of the sidewall of the finished
cartridge case shall fall within the range defined by the grain configuration standards
illustrated in MIL-STD-1170, Figures 1 through 6.
3.11 Workmanship. - The requirements for workmanship are as specified on the
applicable drawings, referenced specifications and the following:
3.11.1 Metal defects. - The cartridge shall be free of folds, wrinkles, deep draw
scratches, scaly metal, dents and other defects.
3.11.2 Foreign matter. - The cartridge shall be free of corrosion, stains, dis-
colorations, dirt, oil and smears of lacquer.
4. QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection. - Unless otherwise specified in the contractor
purchase order, the supplier is responsible for the performance of all inspection
requirements as specified herein. Except as otherwise specified, the supplier may
utilize his own facilities or any commercial laboratory acceptable to the Government.
The Government reserves the right to perform any of the inspections set forth in the
specification where such inspections are deemed necessary to assure supplies and
services conform to prescribed requirements.
4.1.1 Quality assurance terms and definitions. - Reference shall be made to
MIL-STD-109 for definition of quality assurance terms.
4.2 Initial production sample. -At the beginning of regular production, the supplier
shall submit an initial production sample to a Government approved facility for evaluation.
The sample shall consist of 400 cartridges. The sample shall be manufactured in the
same manner, using the same materials, equipment, processes and procedures as will
be used in regular production. All parts and materials, including packaging and packing,
must be the same as used for regular production and shall be obtained from the same
source of supply. After inspection and provisional acceptance at source, the initial
production sample shall be inspected at the Government approved facility for all require-
ments of the drawings and specifications. The Government reserves the right to require
new initial production samples until such time as an acceptable sample is submitted.
4.3 Inspection provisions.
4.3.1 Lot.
4.3.1.1 Submission of product. - The product shall be submitted in accordance with
MIL-STD-105.
3
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business