MIL-DTL-46540C(AR)
(Copies of federal and military specifications, standards and handbooks are available online at
https://assist.daps.dla.mil/quicksearch/ or https://assist.daps.dla.mil or from the Standardization Document
Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111 - 5094.)
2.2.2 Other Government documents, drawings and publications. The following other Government
documents, drawings and publications form a part of this document to the extent specified herein. Unless
otherwise specified, the issues of these documents are those cited in the solicitation or contract.
U.S. ARMY ARMAMENT RESEARCH, DEVELOPMENT, AND ENGINEERING
CENTER (ARDEC) PUBLICATIONS
SCATP-20
-
Ammunition Ballistic Acceptance Test Methods,
Test Procedures for 20mm Cartridges
(This publication is available from US Army ARDEC, AMSRD-AAR-QEM-F, Picatinny, NJ 07806-
5000.)
U.S. ARMY ARMAMENT RESEARCH, DEVELOPMENT, AND ENGINEERING
CENTER (ARDEC) DRAWINGS
7553815
Case, Cartridge, 20mm, M103
7258817
Cartridge, 20mm, Target Practice, M55A2
1575AS300
Cartridge, 20mm, Target Practice, PGU-27/B
7258801
Classification of Defects for Case, Cartridge, 20mm, M103 and
M103B1
(Copies of these drawings may be requested on line at Drawing-Request@pica.army.mil or from US
Army ARDEC, AMSRD-AAR-AIS-TD, Picatinny, NJ 07806-5000.)
2.3 Non-Government publications. The following documents form a part of this document to the
extent specified herein. Unless otherwise specified, the issues of these documents are those cited in the
solicitation or contract.
ASTM INTERNATIONAL
ASTM E18
-
Standard Test Methods for Rockwell Hardness and
Rockwell Superficial Hardness of Metallic Materials
(Copies of this document are available from ASTM International, 100 Barr Harbor Drive, West
Conshohocken, PA 19428-2959 or www.astm.org.)
2.4 Order of precedence. In the event of a conflict between the text of this document and the
references cited herein, the text of this document takes precedence. Nothing in this document, however,
supersedes applicable laws and regulations unless a specific exemption has been obtained.
3. REQUIREMENTS
3.1 First article. When specified, a sample shall be subjected to first article inspection in
accordance with 4.2.
3.2 Parts and subassemblies. Materials, parts and assemblies shall comply with requirements
specified on the applicable drawings and referenced specifications.
2
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business