MIL-L-22624A
5.3 Marking.
5. 3.1 Special marking. None, unless otherwise specified.
5.3.2 Normal marking. In addition to the marking required
by the contract or order, shipping containers shall be
marked in accordance with Standard MIL-STD-129.
6. NOTES
6.1 Intended use. The links covered by this specification
are intended for linking into 20MM ammunition belts for use
with the 20MM Aircraft Gun Mark 11 Mod 5.
Procurement documents should specify
6.2 Ordering data.
the following:
Title, number and date of this specification.
(a)
Size of preproduction sample if different
(b)
from 3.1.
Facility designated to evaluate the prepro-
(c)
duction sample.
(d)
Government-furnished property (see 3.7).
Government-loaned property (see 3.8).
(e)
Lot size If different from 4.3.
(f)
Procedure for resubmittal of rejected lots.
(g)
Preservation, packaging and w.eking levels.
(h)
Special marking of shipping containers if
(i)
required.
Invocation of Specification MIL-Q-9858.
(j)
6.3 Reliability. Extreme care must be exercised in es-
tablishing the production system and quality control
practices for parts covered by this specification to assure
an adequate overall gun system reliability. Each subsystem
must have considerably higher individual reliability than
the overall 7,000 rounds per stoppage needed for the Mark 4
Gun Pods of which this item is a part. These reliabilities
cannot be assured by an after the fact inspection to an AQL
and are therefore beyond the written requirement of the
specification. However, it has been shown that high relia-
bilities can be achieved even though inspection AQL's are
relatively low (ammunition, for example) if a good production
system and control Is followed. To Illustrate the component
requirement, the subsystems must perform to stoppage rates no
greater than those listed below if the 7,000 rounds per stoppage
13
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business