MIL-L-45403D
3.2.3 Dynamic requirement
A belt consisting of 101 links and 100 7.62MM
NATO approved dummy cartridges shall withstand a free drop of one end of the
belt. Full or partial separation of the links from the cartridges shall be
permitted in no more than 10 links from the free end. Partial separation is
defined as the disengagement of the link front, rear, or middle loop, or any
combination thereof, with the cartridge. Testing shall be in accordance with
4.5.5.
3.2.4 Loop gap position. Links shall meet the loop gap relative position
requirements as specified on Drawing F7268389 (Reference detail D). Testing
shall be as specified in 4.5.6.
3.2.5 Functioning. Links shall be capable of being assembled into 100
round belts with 7.62MM NATO approved cartridges and fired in an approved
7.62MM machine gun as listed in 4.5.7 without cracking, breaking, separating
or malfunctioning. Testing shall be as specified in 4.3.
3.3 Marking. Links shall be marked in accordance with MIL-W-13855 and
Drawing No. F 26 389.
Parts, assemblies, subsystems and systems shall be
3.4 Workmanship.
visually examined to determine compliance with the following requirements.
The quality of workmanship shall not adversely affect safety, function,
performance, serviceability, interchangeability, and appearance. Completed
parts and assemblies shall not exhibit defective material or processing such
as: seams, laps, laminations, cracks, fins, extraneous material, visible
steps or irregularities, sharp edges, nicks, scratches, burrs, tool scores and
gouges, deformations, missing operations, improper assembly, missing parts,
stains, corrosion, nonspecified oxidation (rust), unauthorized salvaging
operations (e.g., hammering to shape, repair by welding, straightening,
bending, etc.).
4. QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection. Unless otherwise specified in the
contract or Purchase order, the supplier is responsible for the performance of
all inspection requirements as specified herein". Except as otherwise
specified in the contract or order, the supplier may use his own or any other
facilities suitable for the performance of the inspection requirements
specified herein, unless disapproved by the Government. The Government
reserves the right to perform any of the inspections set forth in the
specification where such inspections are deemed necessary to assure supplies
and services conform to prescribed requirements. Quality assurance terms and
definitions used herein are in accordance with MIL-STD-109.
4.2 Classification of inspections. Unless otherwise specified in the
specification or contract, the following types of inspection shall be
conducted on the unit of the product.
3
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business