MIL-C-60813(AR)
4.4.12 Defect penalty. - In any ballistic test, except function and
casualty, in which the occurrence of a firing defect listed in Table III pre-
vents the obtaining of a reliable result for the characteristic being tested,
an additional shot shall be fired. That particular test shall not be penal-
ized but the total ballistic sample shall be penalized for such defects in
accordance with Table III.
PREPARATION FOR DELIVERY
5.
5.1 Packing. Level A (Worldwide shipment).- The cartridges shall be
packed in accordance with Drawing F7553719.
5.2 Marking and labeling.- Packing boxes shall be marked and labeled in
accordance with the drawing cited in 5.1.
6. NOTES
6.1 Ordering data. - Invitations for bids or request for proposal and
contracts or orders will specify the following:
6.1.1 Title, number and date of this specification.
6.1.2 Type and level of packing.
6.1.3 Provisions for the supply, maintenance and disposition of manda-
tory ballistic test equuipment for acceptance inspection purposes.
6.1.4 provisions for the submission of acceptance of inspection reports
containing final inspection results for each lot of ammunition presented to
the Government.
6.1.5 Requirement for contractor to provide and maintain an inspection
system in accordance with MIL-I-45208, Inspection System Requirements.
6.2 Safety precautions. - Fumes produced by functioning of the spotter-
tracer bullet are considered toxic and inhalation of such fumes should be
avoided. Adequate exhausts should be provided to remove fumes from test
areas.
12
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business