MIL-F-46579D
4.3.1 First article sample.- The sample shall be delivered for inspection
in accordance with first article approval provisions of the contract and
MIL-A-2550, and shall consist of:
Bodies
50
-
Nose caps
50
-
Firing pins
50
-
Rotor detent springs
50
-
Rotors
50
-
Booster holders
50
-
Metal parts assemblies
50
-
4.3.1.1 Inspection.- After inspection bY the contractor and provisional
acceptance by the Government activity, the sample will be inspected in
accordance with the provisions of MIL-A-2550. Failure of the original
first article sample to be in accordance with the applicable drawings
and the requirements of Para. 3, as specified herein, will result in
sample disapproval. (see 6.3)
Quality conformance inspection.
4.4
4.4.1 Submission of Product.- The product shall be submitted in accordance
with MIL-STD-105 or MIL-STD-1235, as applicable.
4.4.1.1 Lot.- A lot shall consist of metal parts produced by one manufacturer
in one unchanged process, in accordance with the same drawings and drawing
revisions, and same specification and specification revision.
4.4.1.2 Lot identification.- Each lot of fuze metal parts shall be identified
in accordance with MIL-STD-1168 and packaged and packed in accordance with
MIL-STD-1169, supplemented as directed by the procuring activity.
4.4.2 Examination.- Examination for major and minor defects shall be per-
formed by the contractor as specified herein. Each part and each assembly
found to be defective shall be rejected.
4.4.2.1 Sampling and acceptance criteria.- The sampling plans and procedures
shall be in accordance with MIL-STD-105 or MIL-STD-1235. TO determine
product acceptability, major or minor defects as listed herein may be con-
sidered collectively on a class basis or they may be considered individually.
However, where major defects are considered collectively on a class basis,
the acceptance number for any individual defect of the class shall be
limited by the assigned Acceptable Quality Level (AQL) for individual
defect associated with the class. (see 4.4.2.2.c) In addition, where
MIL-STD-1235 is used, sampling plans applicable to a class shall not be
used for major defects. (see 6.5)
4
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business