MIL-P-5060-1A(MU)
3.10 Workmanship. -The requirements for workmanship are as specified by
applicable drawings, referenced specifications and the following:
3.10.1 Processing defects. -The components and assemblies shall be free
from dents, scratches, cuts, sharp edges, burrs, and other forms of sub-
standard workmanship.
3.10.2 Cleanliness. -The components and assemblies shall be free from all
foreign matter.
4.
QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection. -Unless otherwise specified in the
contract or purchase order, the supplier is responsible for the performance
of all inspection requirements as specified herein. Except as otherwise
specified in the contract or order, the supplier may use his own or any
other facilities suitable for the performance of the inspection require-
ments specified herein, unless disapproved by the Government. The Government
reserves the right to perform any of the inspections set forth in the speci-
fication where such inspections are deemed necessary to assure supplies and
services conform to prescribed requirements.
4.1.1 Quality assurance terms and definitions .-Reference shall be made to
MIL-STD-109 for definition of quality assurance terms.
4.1.2 Bar stock verification. -Independent of tests and inspections per-
formed by the steel bar supplier, an examination shall be made on each lot
of bars. The inspection and tests used to verify the bar stock quality
shall be as specified by MIL-S-46070, Table IV, using the requirements,
acceptance criteria and test methods referenced therein, with the following
modifications:
Chemical composition: Sulphur only is required.
Mechanical properties: Unmodified.
Grain size: Unmodified.
Soundness:
Macro-etch
Billet: See Note 1.
Bar: See Note 1.
Magnetic: See Note 1.
Surface decarburization: Not required.
Dimensions: Diameter only.
Workmanship:
See Note 1.
The supplier's macro-etch, magnetic and visual inspection shall
NOTE 1:
be monitored to the extent necessary to assure compliance with
MIL-S-46070.
4
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business